K2 Systems

Solar fastener 8x85 / M10x50 with calotte and hardened tip (without adapter plate). For fixing the K2 Systems components in the steel substructure, suitable for trapezoidal sheet metal covering. With European Technical Assessment (ETA). Material: stainless steel A2. Article is procured on the basis of order - return excluded. The following technical data must be submitted with enquiries/orders: Top chord width (mm) - Profile height (mm) - Clear width at bottom chord (mm) - Roof colour (RAL). P| Articles procured on order-related basis

Solar fastener 8x195 / M10x50 with fiber cement seal and hardened tip. For fixing the K2 Systems components in the steel substructure, suitable for corrugated fibre cement roofing. Material: stainless steel A2. Article is procured on the basis of order - return excluded.

Solar fastener 8x155 / M10x50 with fiber cement seal and hardened tip. For fixing the K2 Systems components in the steel substructure, suitable for corrugated fibre cement roofing. Material: stainless steel A2. Article is procured on the basis of order - return excluded.

Solar fastener 8x85 / M10x50 with fiber cement seal and hardened tip. For fixing the K2 Systems components in the steel substructure, suitable for corrugated fibre cement roofing. Material: stainless steel A2. Article is procured on the basis of order - return excluded.

Solar fastener 8x115 / M10x50 with fiber cement seal and hardened tip. For fixing the K2 Systems components in the steel substructure, suitable for corrugated fibre cement roofing. Material: stainless steel A2. Article is procured on the basis of order - return excluded.

Thread-tapping screw 6x38 mm for non-cutting processing. Material: stainless steel A2, EPDM

Thread-tapping screw 6x25 mm for non-cutting processing. Material: stainless steel A2, EPDM

The SingleBoard allows you to add an additional roof hook of SingleHook 1.1 in between two rafters. It also allows you to move existing Roof Hook individually. This can be the case in roof edge areas or with obstacles. Material: Aluminium EN AW-6063 T66

Bracket of the SingleHook 4S incl. Climber and allen bolt. To be used with the K2 SingleBoard 3S/4S (2001972). Material: Aluminium EN AW-6063 T66 and stainless steel A2

K2 BlackCover for black cover of the rail ends of the K2 SingleRail 50. Length of cover: 150 mm. Material: PA 6 GF30

Solar Cable Manager with connecting possibility for outdoor-installation. LxW: 200x4.6 mm S| Item phase-out

Seam clamp for mounting the SingleRail on various round bulb seams such as Kalzip, Bemo, Aluform or RIB-ROOF Evolution. Material: clamp: aluminum, screws: stainless steel A2

Exhibition piece of the insertion system with 25 cm SolidRail Light, 25 cm Insertion Rail , SolidHook 4S+, cross connector set, rail stop, end bracket and cable duct clip. S| Item phase-out

Short rail with static confirmation in K2 Base. For direct mounting in landscape orientation on sheet metal roofing. Length: 250 mm. Material: Aluminium EN AW-6063 T66, EPDM

Plastic profile to hold the DC wiring in the K2 InsertionRail System. Material: polycarbonate S| Item phase-out